Home >

80 PERCENT ARMS GEN 3 EASY JIG SPEEDMILL REPLACEMENT END MILL - 22000-EM
80 PERCENT ARMS 80% ARMS GEN 3 EASY JIG SPEEDMILL 22000-1A ​22000-2B 22000-3C 22000-4D A/1 B/2 C/3 D/4 40116


 
MSRP: $33.00
Our Price: $28.99

Stock Status:(Out of Stock)

Product Code: 80PA-22000-EM




  MY SHIPPING ADDRESS IS NOT LOCATED IN: CA, DC or NY.

   MY BILLING ADDRESS MATCHES MY SHIPPING ADDRESS. ***NO EXCEPTIONS!

   A 15% CANCELLATION FEE WILL APPLY IF WE HAVE TO CANCEL YOUR ORDER.

Qty:  
Description
 
80 PERCENT ARMS GEN 3 EASY JIG SPEEDMILL REPLACEMENT END MILL
MPN: 22000-EM

This is a replacement end mill for the Easy Jig® Gen 3 Speedmill™. It's easy to keep a few extra on hand and quickly swap out by heating the Speedmill™ up with a torch or induction heater.

Description:
  • Solid Carbide
  • Fluted Specifically for Aluminum
  • For the Easy Jig® Gen 3 Speedmill™
  • Made in the USA

Average Rating: Average Rating: 4.5 of 5 4.5 of 5 Total Reviews: 3 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 End mill replacement bit June 7, 2023
Reviewer: Troy from Mocksville, NC United States  
Nice end mill bit. I am hoping with the small side cutting surface it will prevent damaging the topplate of the jig.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Amazing (userfriendly) April 17, 2023
Reviewer: Arthur Green  
Fool proof ,nothing easier,love it

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
4 of 5 easy to replace, should not have worn out... February 27, 2023
Reviewer: Mark from Oregon  
did 4 parts with the original bit, used cutting oil and a vacuum to remove chips. Bit shattered about 4 layers from finishing. Now changing the bits was super easy and I finished the part, but not impressed with the longevity.

Was this review helpful to you?